• Secure payment

Guides

Anatomy of a cigar: head, body and foot

By Vitola Room Editorial TeamVitola Room Editorial · 4 min read
A cigar shown from head to foot with its parts labelled

A cigar is built from three parts along its length, the head, the body and the foot, and from three leaf components inside it: the filler, the binder and the wrapper. Knowing how these parts fit together explains why two cigars of the same size can look, burn and taste so differently. This guide walks through the parts in the order a smoker meets them.

The head

The head is the closed end that goes into the mouth. It is finished with a small cap, usually cut from wrapper leaf, which holds the outer leaf in place and stops it unravelling. Before smoking, the cap is cut, punched or pierced so that smoke can pass through. The shape of the head varies with the vitola: a parejo has a plain rounded head, while figurados may taper to a point or end in a twisted pigtail.

Because the head is where lips and tongue make contact, its finish matters for comfort. A neat, firm cap with no loose edges is a sign of careful rolling. See The Cuban triple cap and Pigtail caps and shaggy feet for the finishes in more detail.

The body

The body is the main length of the cigar, between head and foot. It is the part you see and handle, and it is where the three leaf components are visible in combination. The outside is the wrapper, a single carefully selected leaf rolled around the rest in a spiral. Under it lies the binder, and inside that the filler bunch.

The body also carries the ring gauge, the diameter measured in sixty-fourths of an inch, and the length, which together define the vitola. A thicker body generally has more filler and burns more slowly, while a thinner one gives a different balance between wrapper and filler flavour.

The foot

The foot is the open end that is lit. Here the cross-section of the cigar is exposed, and you can sometimes see how the filler leaves are arranged. A well-made cigar has a flat, even foot where the filler leaves are packed evenly with no large gaps. Some cigars leave a small tuft of filler leaf extending past the wrapper, often called a shaggy foot, which is a stylistic finish rather than a fault.

The foot is also where some makers place a second, smaller band, while others use no band at all, depending on the maker's habits.

The three leaf layers

Inside the body, the filler is the bunch of leaves that supplies most of the flavour and strength. The binder is a sturdier leaf that wraps the bunch and holds it together. The wrapper is the outermost leaf, chosen for appearance, texture and its contribution to aroma. Each has its own page: the wrapper (capa), the binder (capote) and the filler (tripa).

How the parts work together

The parts do separate jobs. The wrapper gives look and first impression, the binder gives structure and helps the burn, and the filler supplies body and complexity. The head controls how the cigar feels in the mouth, and the foot controls how it ignites. When one of these is poorly made, the result is often a faulty draw or an uneven burn, which is covered in Construction faults.

Reading a cigar before you smoke it

A quick inspection tells you a lot. Turn the cigar slowly and look at the wrapper for tears, lifted edges or unusually dry patches. Run your fingers along the length and feel for an even firmness, neither rock hard nor spongy. Look at the head to see whether the cap is tidy, and at the foot to see whether the filler is level. None of these checks is a guarantee, but together they give a reasonable picture of how carefully the cigar was made.

Parts and vocabulary

Cigar vocabulary is full of Spanish words, because the craft grew up in Spanish-speaking regions. Capa, capote and tripa are the wrapper, binder and filler. Cabeza is the head and pie is the foot. Learning these words helps when reading labels and descriptions, and it makes conversations with other enthusiasts easier. The shape names, such as parejo and figurado, are covered in What is a vitola?.

Frequently asked questions

What are the three main parts of a cigar?

Along its length a cigar has a head, a body and a foot. Inside it is made of filler, binder and wrapper leaves.

Which end of the cigar do I light?

You light the foot, the open end. The head is the capped end that you cut and place in your mouth.

Is a tuft of tobacco at the foot a defect?

Not necessarily. A small tuft of filler left beyond the wrapper is a deliberate finish on some cigars, usually called a shaggy foot.

Reader questions

Questions & answers

No questions yet. Ask the first one.