• Secure payment

Guides

How a cigar burns: combustion and draw

By Vitola Room Editorial TeamVitola Room Editorial · 3 min read
A lit cigar showing an even burn line and firm ash

A cigar burns through a slow, smouldering combustion of tobacco leaf, and the draw is the way air and smoke move through it when you puff. A good burn is level and steady, and a good draw gives a little resistance without strain. This article explains the basics of how a cigar burns and what influences it.

Smouldering, not flaming

A cigar does not burn with an open flame. After lighting, the tobacco smoulders: a glowing zone at the foot slowly consumes the leaf, and the tobacco just behind it is heated and gives off smoke. Between puffs, the cigar continues to smoulder gently, and a puff draws more air through the lit zone, raising its temperature and sending smoke down the cigar.

The draw

The draw is the resistance you feel when you pull air through the cigar. Too tight a draw is tiring and may produce a bitter smoke, while one that is too loose can overheat the cigar and make it taste harsh. Good filler arrangement, discussed in The filler (tripa), leaves air channels that give a steady, moderate draw.

The burn line

Ideally, the burning edge is level and moves steadily. Uneven burning shows up as canoeing, where one side runs ahead, or tunnelling, where the centre burns faster than the outside. Causes include uneven lighting, unequal filler packing, a poor binder or draughts. Slightly uneven burns often correct themselves, and a gentle touch-up with a flame can help.

The role of the leaves

Different leaves burn differently. Volado burns readily, seco burns steadily, and ligero burns more slowly. A blend balances them so the cigar stays lit and burns evenly, as covered in Ligero, seco and volado. The binder also supports an even burn, see The binder (capote).

The ash

The ash is what remains after the tobacco burns. A firm ash that holds for a good while is often taken as a sign of well-fermented, well-grown leaf, though it is not a reliable measure of quality. There is no need to tap it constantly. Let it fall when it is long enough to drop naturally.

Smoking at a gentle pace

Puffing too often raises the temperature and can make the smoke harsher, so most smokers take a puff every minute or so and let the cigar rest in between. Faults that disturb the burn are described in Construction faults.

Lighting the cigar

Good lighting sets up an even burn. Hold the foot a little above the flame and rotate the cigar so that the whole surface of the foot warms and glows. Draw gently so that the heat spreads across the end. Avoid putting the foot into the flame, which can scorch it. A cigar lit evenly is much less likely to canoe.

Why a cigar goes out

A cigar can go out for several reasons. Leaving it too long between puffs lets the glowing zone cool. A damp cigar may struggle to stay lit, and a dry one may burn too fast. Wind can also cool one side. If your cigar goes out, there is no need to worry: it can be relit, though the first puffs may taste stale. Knock off the loose ash and blow gently through the cigar to clear the old smoke first.

Why draw and burn are linked

The draw and the burn influence each other. A loose draw means more air passes through, raising the temperature of the glowing zone and making the cigar burn faster. A tight draw means less air flows and the glow can fade. Aim for a draw that feels like gentle resistance, and adjust your puffing to keep the temperature moderate. A calm, regular pace gives the best chance of an even, cool burn.

Frequently asked questions

Why does one side of my cigar burn faster?

That is canoeing. Common causes are uneven lighting, uneven filler packing or draughts, and it often corrects itself.

How often should I puff?

Usually about once a minute, so the cigar does not overheat. Letting it rest keeps the smoke cooler.

What makes a draw too tight?

Filler packed too densely, a plug, or a very firm cigar. Making sure the cut is open can help.

Reader questions

Questions & answers

No questions yet. Ask the first one.

All articles