• Secure payment

Guides

Identifying and dealing with cigar mould

By Vitola Room Editorial TeamVitola Room Editorial · 3 min read
Identifying and dealing with cigar mould

Mould on cigars appears as fuzzy or powdery growths, usually white, blue, green or grey, that sit on the surface of the wrapper or the foot. It is caused by excess moisture and poor airflow, and it needs to be told apart from plume, a harmless crystalline bloom that sometimes forms on well-aged cigars.

What mould looks like

Mould typically forms in soft, cotton-like patches or in colourful spots that can be white, green, blue or even black. It often appears first on parts of the cigar that stay damp, such as the foot or places where cigars touch each other. It tends to smell musty or stale, not like tobacco. A key characteristic is that it grows and spreads, and that it can penetrate the wrapper and the filler beyond the surface.

Telling mould from plume

Plume, also called bloom, is a fine crystalline deposit that some people associate with long ageing. Under a light it can sparkle faintly, and it is usually described as being made of tiny crystals rather than fibres. It often wipes away cleanly with a soft brush, and it does not smell musty. Mould, by contrast, looks fluffy, may leave stains and smells off. A useful test is to gently brush the spot: plume tends to come off and may leave the wrapper looking normal, while mould smears or leaves a mark. If you are unsure, treat it as mould until proven otherwise.

Why mould appears

Mould needs moisture, warmth and still air. Humidity that stays well above the target for a long time, a humidor placed in a warm spot or a box packed so tightly that air cannot move all raise the risk. New wooden boxes that have been over-seasoned, or humidifiers contaminated with growth, can also be a source. Fixing the conditions is essential, because removing visible mould while leaving the environment unchanged will not solve the problem.

What to do about it

If you find mould, remove the affected cigars right away so spores do not spread. Light surface mould is sometimes brushed off with a soft, clean, dry brush, ideally outdoors and away from the other cigars, followed by a period of drier storage. However, there is disagreement over whether affected cigars are safe to smoke, and many people discard them, especially if the growth has penetrated the wrapper. Do not smoke cigars with heavy or deep growth.

Then address the box. Remove all cigars, wipe the interior gently with a lightly dampened cloth, allow it to dry thoroughly, and replace the humidifier if it may be contaminated. Reduce the humidity target and improve airflow before reloading.

Preventing a recurrence

Keep humidity near the intended target and verify your hygrometer. Avoid warm locations, leave a little space between cigars, and inspect the contents regularly. Open the lid from time to time to refresh the air. If your climate is hot and humid, consider a slightly lower humidity target and a smaller humidifier. Quarantine new purchases and inspect them before adding them to your main box.

When to seek a second opinion

If you cannot tell whether a mark is plume or mould, photograph it in good light and compare it with reliable reference images, or ask an experienced retailer or fellow collector. Do not make a decision on a single glance in dim light. Look at the shape of the growth, whether it has a fibrous texture, and whether it smells. A harmless bloom tends to be uniform and dry, while mould tends to be patchy and slightly damp.

Err on the side of caution. A cigar is easy to replace, and your health and the rest of your collection are not. If a whole box has been affected, it is better to start again with a clean setup than to hope the problem fades.

Frequently asked questions

Is white powder on a cigar always mould?

No. It may be plume, which is a crystalline bloom and is usually harmless. Check the texture and smell, and when in doubt treat it as mould.

Can I smoke a cigar that had mould brushed off?

Opinions differ. Many people discard them, particularly when the growth was heavy or penetrated the wrapper.

Why does mould keep returning?

The conditions are probably still too wet, warm or stagnant, or the humidifier or box is contaminated. Fix the environment, not just the cigars.

Reader questions

Questions & answers

No questions yet. Ask the first one.

All articles