• Secure payment

Guides

Calibrating a hygrometer with the salt test

By Vitola Room Editorial TeamVitola Room Editorial · 3 min read
Calibrating a hygrometer with the salt test

The salt test is a simple home method for checking how accurate a hygrometer is. It relies on the fact that a sealed container holding a damp mixture of ordinary salt reaches a well-known relative humidity of around 75 percent at room temperature, which gives you a reference point to compare against.

Why hygrometers need checking

Many humidors ship with small analogue dials or inexpensive digital gauges that can be off by several percentage points. Because the 70 percent guideline is itself a fairly narrow target, an inaccurate gauge can lead you to dry or over-wet your cigars while believing everything is fine. Hygrometers can also drift over time, and some are sensitive to being knocked or exposed to extreme conditions. A routine check every few months is a sensible habit.

The science in a sentence

When a saturated salt solution sits in a closed space, the air above it settles at a characteristic humidity that depends on the type of salt and, to a small degree, on temperature. For ordinary sodium chloride at normal room temperatures, the commonly cited figure is about 75 percent. The method works because that figure is physically determined by the salt, not by the gauge.

How to carry out the test

Take a small bottle cap or shallow lid and fill it with table salt. Add a little water, a few drops at a time, until the salt is damp like wet sand but with no standing liquid. Place the cap and your hygrometer together inside a sealed container such as a zip bag or a small plastic box, keeping them out of direct contact. Leave the container in a place with a stable room temperature, away from sun, for around eight hours or overnight.

After that time, read the hygrometer without opening the container for longer than necessary. Note the value it shows. The difference between that reading and 75 percent is your gauge’s error at that point.

Interpreting and applying the result

If a digital hygrometer reads, for example, 71 percent when the reference is 75, then it is reading roughly four points low. You can mentally add four to its readings, or, if the device has a calibration function, adjust it according to the maker’s instructions. Some analogue dials have a small screw at the back for adjustment. If the correction is large or the device will not settle, replacing it is often more practical than trying to compensate.

Be aware that a single reference point does not guarantee accuracy across the whole range. A gauge could be right at 75 and still be slightly off at 65. For general cigar storage, however, one check near the working range is usually good enough.

Tips for a reliable result

Use plain salt without anti-caking additives where possible, keep the setup out of drafts, and avoid opening the container repeatedly. Make sure the salt remains damp but not dissolved into a pool. If your room temperature is unusually hot or cold, the reference value shifts slightly, so aim for a normal living-room temperature. Ready-made calibration kits based on the same principle are also sold.

Choosing and placing a hygrometer

Digital hygrometers are generally easier to read and often more accurate than cheap analogue dials, though quality varies widely, and a high price is no guarantee. Whatever you buy, place it where air can reach it, normally at the cigar level and away from the humidifier, because a sensor sitting right beside a wet device will report a higher figure than the rest of the box. Having two gauges lets you spot a drifting instrument quickly, since disagreement between them is a clear signal that at least one needs checking.

Keep a short note of the correction you found, with the date. When you repeat the test a few months later, comparing the two results shows whether the device is stable or slowly drifting.

Frequently asked questions

How accurate is the salt test?

It is accurate enough for home use when carried out carefully, but it gives a single reference point, so treat it as a good check rather than a laboratory calibration.

Can I leave the test running longer than a night?

Yes, but a number of hours is usually enough for the readings to settle. Longer is fine as long as the salt stays damp and the container stays sealed.

What if my hygrometer reads very differently from 75 percent?

A large error suggests the gauge is poor or damaged. Consider replacing it instead of relying on a heavy correction.

Reader questions

Questions & answers

No questions yet. Ask the first one.