• Secure payment

Guides

Toasting the foot and lighting a cigar

By Vitola Room Editorial TeamVitola Room Editorial · 3 min read

Toasting is the practice of warming the foot of a cigar with a flame, without puffing, before lighting it. It prepares the tobacco to catch evenly and helps the cigar burn straight from the first puff.

What toasting means

The foot of a cigar is the open end that is lit. Toasting means holding it near a flame, slowly rotating it, so that the tobacco at the foot begins to glow and warm. The aim is to prepare the surface, not to light the cigar fully.

Many smokers consider toasting a ritual as much as a technique. It slows the start of the smoke and offers a moment to appreciate the cigar before lighting.

Why it helps

A cigar is made of layers of leaf, and each layer may light at slightly different rates. Applying a gentle flame to the whole foot encourages the layers to catch together. This helps prevent an uneven burn, in which one side burns faster than the other.

Toasting also lets the smoker see the foot clearly, check that no pieces of tobacco are loose and make sure the flame is evenly applied.

Step by step

  1. Cut the head of the cigar first, so you can draw immediately.
  2. Hold the cigar at an angle, the foot pointing toward the flame.
  3. Keep the foot just above the tip of the flame, not in it, so the heat warms the tobacco without charring it.
  4. Rotate the cigar slowly so the whole circumference is warmed evenly.
  5. When the edge begins to glow, bring the cigar to your mouth.

Lighting

After toasting, place the cigar in your mouth, hold the flame close to the foot and draw gently while rotating the cigar. Puff softly and steadily until the foot is evenly lit all around. The ember should look uniform, with no dark patches.

Avoid drawing too hard. Heavy puffing in the first moments can overheat the tobacco and bring out harsh flavours. A gentle, patient approach works best.

Check the foot

Once lit, look at the foot. If one side is lagging, touch it with the flame again for a moment. An even ring of glow is the target. Blow gently across the foot to check that all of it is burning.

A small amount of unevenness is normal and often corrects itself within the first few centimetres. Persistent issues are covered in our article on fixing an uneven burn.

Common mistakes

  • Putting the foot in the flame. This scorches the tobacco and can leave a bitter taste.
  • Skipping toasting entirely. It is not essential, but it often makes lighting smoother.
  • Using a poor fuel. Some fuels can taint the cigar, as explained in another article.
  • Rushing. Patience in the first minute pays off.

Is it required?

Some smokers skip toasting with thin cigars, which light easily, and simply apply the flame while puffing. Others toast every cigar. It is a matter of preference, though careful lighting is always worth the time.

A relaxed pace

The best advice for lighting is not to hurry. A cigar will not mind waiting a minute, and the first moments set the tone for the whole smoke. Take time to look at the foot, warm it patiently and draw softly. If you are lighting outdoors, find a sheltered spot first. If you are lighting a large ring gauge, expect to spend a little longer than with a slim cigar, since there is more surface to ignite. After the first few puffs, step back and enjoy the cigar at a calm rhythm. Careful lighting is the foundation on which a good burn is built, and it costs only a little patience.

Frequently asked questions

Do I have to toast a cigar before lighting it?

It is not required, but toasting helps the foot catch evenly and reduces the chance of an uneven burn. Many smokers consider it a good habit.

How close should the flame be to the foot?

Keep the foot just above the flame, not touching it. The cigar should be warmed, not charred.

Should I puff while toasting?

No. Toasting is done without drawing. Puffing begins once the foot is warmed and you start lighting.

Reader questions

Questions & answers

No questions yet. Ask the first one.