• Secure payment

Guides

Seasoning a new humidor

By Vitola Room Editorial TeamVitola Room Editorial · 3 min read
Seasoning a new humidor

Seasoning is the process of conditioning the bare wood of a new humidor with moisture so that it stops drawing water out of the cigars you place inside. It is done before the first cigars go in, and it is usually the single most important step in setting up a box.

Why a new humidor needs seasoning

Untreated cedar is relatively dry. If you put cigars straight into a fresh box, the wood will quietly absorb moisture from them until it reaches its own balance with the air, leaving the cigars drier than intended. Seasoning pre-loads the lining with moisture so that it is already near equilibrium at your target humidity. It also gives you the chance to check how well the lid seals and how steady the readings are before anything valuable is inside.

The basic method

The most widely recommended approach is gentle and patient. Prepare your humidification device by soaking it with distilled water or the solution the manufacturer specifies, and then pour out any excess so that it is damp but not dripping. Place it in the closed box, close the lid and leave it. Check the hygrometer every day or two. When the reading climbs and then stays around your target for a couple of days, the wood is probably saturated enough to start receiving cigars.

Expect this to take several days and sometimes a week or more, depending on the size and construction of the box. Larger cabinets generally need longer. Do not try to hurry the process by flooding the interior.

What to avoid

Do not wipe the interior with a wet cloth or spray it heavily with water. Wood that is soaked on the surface can warp, crack, loosen joints or swell the lid so it no longer closes properly, and the dampness can encourage mould. Some people use a light damp cloth wrung out almost completely, but a humidifier-led approach is gentler and gives you more control. Never use tap water if you can avoid it, and avoid adding flavoured or scented liquids, as these can transfer odours to the cigars.

Checking the result

Once the humidity has been stable at your target for a few days, you can begin to load cigars, ideally in stages rather than all at once. Adding a few at a time lets you watch the reading. Because newly added cigars may be a little drier or wetter than your target, the number may dip or rise for a short period. If it behaves sensibly over a couple of weeks, the seasoning has worked.

If the reading will not rise, check the seal and the condition of the humidifier. If it climbs too high, remove or reduce the water source and leave the lid ajar briefly to let the interior settle.

Re-seasoning later

You may need to repeat the process if the humidor has been left empty and dry for a long time, or if you have cleaned it. The steps are the same: charge the humidifier, close the box and monitor until stable. Treat it as ordinary maintenance rather than a failure.

A realistic timeline

To make the process concrete, imagine a medium desktop box. On day one you charge the humidifier and close the lid. Over the next two or three days the reading climbs from the dry level of the room toward the target. By the end of the first week it should be close to the number you want and holding. If it has stalled well below the target, the wood may still be absorbing, and you can leave it a little longer. If it overshoots, remove the device for a day and let the interior settle.

Patience pays off here. Boxes seasoned slowly tend to hold humidity more steadily afterwards, and the first loading of cigars goes more smoothly because the lining no longer competes with them for moisture. Treat the first week as an investment in everything that follows.

Frequently asked questions

How long does seasoning take?

Commonly several days to a week or more. The exact time varies with box size and wood, so rely on the hygrometer rather than the calendar.

Can I season with a wet sponge directly on the wood?

It is better to avoid direct wetting. Excess water can warp the lining and encourage mould. Use a moistened humidifier instead.

Do I need to season a humidor that comes with a pre-treated lining?

Some makers pre-treat their boxes, but a short check period with a charged humidifier is still sensible before loading cigars.

Reader questions

Questions & answers

No questions yet. Ask the first one.