• Secure payment

Guides

The punch cut

By Vitola Room Editorial TeamVitola Room Editorial · 3 min read

A punch cut makes a small, round hole in the cap of a cigar instead of removing the cap. The tool, called a punch cutter, bores into the head and leaves the surrounding ring of cap intact, so the wrapper stays firmly attached.

What a punch does

A punch cutter is essentially a small, sharp tube. It is pressed into the centre of the head and twisted slightly or pushed straight in, and it removes a plug of tobacco to create an opening. Because it works through the centre, the edge of the cap is never cut.

The result is a clean, round channel for the smoke. Many punches are simple tools, often attached to a keychain or built into a multi-function cutter.

Advantages

The most commonly cited benefit is wrapper security. With the cap left whole, there is little chance of the wrapper unravelling at the head. Punches also reduce the amount of loose tobacco that reaches the mouth.

The narrow opening sends the smoke through a tighter stream, which some smokers feel concentrates the flavour, and the intact head can feel firmer between the lips.

Limitations

The same small opening that protects the cap can limit airflow. On thin cigars, a punch can be too large for the cigar and weaken the head. On larger ring gauges, a small punch may give a draw that feels restricted.

A punch also works poorly on tapered heads. In a pyramid or torpedo, the tip narrows and a punch may either fail to enter cleanly or take away too much of the point. See the article on cutting figurados for this.

How to use a punch

  1. Find the centre of the head and hold the cigar steady.
  2. Press the punch gently into the cap, rotating it slightly if the model calls for it.
  3. Push in a few millimetres, enough to pass through the cap into the filler.
  4. Remove the punch and clear out any plug of tobacco.
  5. Take a dry draw to confirm the airflow.

Take care to keep the punch straight. An angled hole creates an uneven draw and may even exit through the side of the head.

Punch size and ring gauge

Punches come in a variety of diameters. A punch that is a good fit for a thick cigar may be too wide for a slim one, because it removes too much of the head and leaves little supporting cap. Matching the punch to the cigar is important.

Some smokers make two or three small holes with a smaller punch to widen the airflow while keeping the cap intact. This can be a useful workaround if the draw is stubbornly tight.

Cleaning and care

Punches clog with tobacco and oils. After use, clear the tube with a wooden toothpick or a thin pin and wipe it dry. A clean, sharp punch edge cuts smoothly, while a clogged or blunt one tends to crush the filler.

When a punch is a sensible choice

A punch is especially handy when the smoker wants to keep the head fully intact, for instance with a cigar that has a delicate wrapper. It is also useful when travelling, as small punches fit easily in a pocket. Some cigars are made with a head that tapers slightly, and a small punch can sometimes work well on them. As always, test with a dry draw. If the cigar feels too restricted, the punch has done its job as a first step and a different cut can follow. There is no penalty for trying a punch first and switching if needed, provided the cap is still intact when you change your mind.

Frequently asked questions

Does a punch cut leave the cap on the cigar?

Yes. A punch makes a hole in the centre of the cap and leaves the surrounding ring in place, which helps hold the wrapper on.

Is a punch cut good for thin cigars?

It can be hit and miss. A punch that is too large for a thin cigar may weaken the head, while a smaller punch may work well.

What should I do if the draw is too tight after a punch?

You can make a second small hole beside the first or switch to a larger cut. A dry draw before lighting helps you decide.

Reader questions

Questions & answers

No questions yet. Ask the first one.

All articles