• An encyclopedia of Cuban cigars

Guides

Cigar Size Chart: Cuban Vitolas de Galera by Size

By Vitola Room Editorial TeamVitola Room Editorial · 5 min read

Cigar sizes are described by two figures: length, in inches or millimetres, and ring gauge, which is the diameter in 64ths of an inch. Cuban factories name each format with a vitola de galera, such as Robustos (ring gauge 50, 124 mm long) or Prominentes (ring gauge 49, 194 mm long), and the chart below gathers those names in one place.

How to read a size

Take a cigar listed as 52 x 150. The 52 is the ring gauge: 52/64 of an inch, or about 20.6 mm across. The 150 is the length in millimetres, about 5⅞ inches. English-language listings often write the length in inches first, so "6 x 54" normally means six inches long with a ring gauge of 54. The order of the numbers is a convention, not a rule, so check which unit is attached to each figure. In the chart below, the ring gauge comes first and the length second.

For the theory behind each number, see ring gauge explained and cigar length and measurements.

The chart

The table lists Cuban vitolas de galera in order of length, from the shortest to the longest. The last column leads to the article on that format.

Vitola de galeraRing gaugeLength (mm)Length (in)ShapeCommon commercial nameRead more
Half Corona44903½Parejo–small formats
Minutos421104⅜Parejo–small formats
Laguito No.3261154½ParejoPanetelaLaguito family
Laguito No.4521194⅝Parejo–Laguito family
Robustos501244⅞ParejoRobustoRobusto
Hermoso No.4481275Parejo–Hermoso No. 4
Marevas421295⅛ParejoPetit CoronaPetit Corona
Edmundo521355⅜Parejo–Edmundo
Coronas421425⅝ParejoCoronaCorona
Coronas Gordas461435⅝Parejo–reading factory names
Laguito No.5541445⅝Parejo–Laguito family
Cañonazo521505⅞Parejo–Cañonazo
Laguito No.2381526Parejo–Laguito family
Piramides521566⅛FiguradoPyramidPyramid
Cervantes421656½ParejoLonsdaleLonsdale
Laguito No.6561666½Parejo–Laguito family
Dalia431706¾Parejo–Dalia
Julieta No.2471787ParejoChurchillChurchill
Laguito No.1381927½ParejoLanceroLaguito family
Prominentes491947⅝ParejoDouble CoronaDouble Corona
Gran Corona472359¼Parejo–reading factory names

A dash in the commercial-name column means that no single widely used equivalent is given here. The inch figures are converted from the millimetres and rounded to the nearest eighth of an inch.

Parejos and figurados in the chart

A parejo has straight sides and an open foot, so two numbers describe it completely. A figurado has a shaped body, and in the chart the only one is the Piramides, whose ring gauge is measured at the widest point, the foot. Torpedoes and other shaped cigars follow the same logic: the stated gauge is the thickest part. See parejos vs figurados and torpedo and belicoso for the shapes themselves.

Small, medium and large formats

There is no official size classification, so this page uses a simple grouping by length alone. The boundaries are an editorial convenience, not an industry standard.

  • Small (under 130 mm): Half Corona, Minutos, Laguito No.3, Laguito No.4, Robustos, Hermoso No.4 and Marevas.
  • Medium (130 to 160 mm): Edmundo, Coronas, Coronas Gordas, Laguito No.5, Cañonazo, Laguito No.2 and Piramides.
  • Large (over 160 mm): Cervantes, Laguito No.6, Dalia, Julieta No.2, Laguito No.1, Prominentes and Gran Corona.

Length is only half the picture. A 52-gauge Cañonazo and a 38-gauge Laguito No.2 are almost the same length but very different in thickness, which is why a ring gauge always belongs next to a length. Formats of 50 gauge and above are covered in large ring gauge formats, and how long a format lasts depends on the smoker and the pace, as discussed in smoking time by vitola.

Metric and imperial rounding

Millimetres are the working unit in Cuban catalogues, so the millimetre column is the primary figure and the inch column is a conversion. One inch is 25.4 mm, so 150 mm is 5.9 inches, which a table may print as 5⅞. Cigars are made by hand, and the published size is the intended one: individual cigars can differ by a few millimetres. Where two tables disagree by a millimetre or a fraction of an inch, rounding is the usual explanation. The figures in the chart come from reference tables and were not measured from cigars.

Notes on regional naming

Churchill, Corona and Lonsdale are commercial names (vitolas de salida) and, in the chart, correspond to the factory names Julieta No.2, Coronas and Cervantes. The same commercial name does not always carry the same dimensions in every brand's line, which is why the numbers are more reliable than the label. The difference between the two kinds of name is explained in vitola de galera vs vitola de salida and reading factory vitola names. The Laguito numbers refer to shapes associated with the El Laguito factory in Havana; see the Laguito family.

The current official sizes are published by Habanos S.A. in its catalogue; reading the Habanos catalogue shows how to interpret it, and Min Ron Nee's encyclopaedia is a long-standing printed reference. Tobacco is harmful and addictive, and this chart is written for adults.

Frequently asked questions

How are cigar sizes measured?

By length and ring gauge. Length runs from foot to head and is given in inches or millimetres. Ring gauge is the diameter in 64ths of an inch, so a 50 gauge cigar is 50/64 of an inch across, about 19.8 mm.

How do cigar sizes work?

Each format has a name and a pair of numbers. The name, such as Robustos, is the label; the numbers are what define the shape. Two cigars with the same length and ring gauge are effectively the same size, whatever they are called.

How do you read cigar sizes?

Find the ring gauge and the length, and check the unit of the length. A listing of 52 x 150 mm means a ring gauge of 52 and a length of 150 mm, about 5⅞ inches.

What cigar size is 6x54?

In the usual English-language convention it is six inches long (about 152 mm) with a ring gauge of 54, which is 54/64 of an inch, about 21.4 mm across. Because the order of figures is a convention, confirm the units on the listing.

What cigar sizes are there?

The chart above lists 21 Cuban vitolas de galera, from 90 mm to 235 mm in length and from ring gauge 26 to 56. Brands add further names, and the Habanos S.A. catalogue is the place to check the current range.

What is the difference in cigar sizes?

Length changes how long a cigar is; ring gauge changes how thick it is. The shape, parejo or figurado, is a third difference. Size says nothing about flavour or strength, which depend on the tobacco.

Why can the same name have different sizes?

Commercial names are applied by brands and eras, not by a single standard, so a name can cover slightly different dimensions. Factory names are more consistent, and the length and ring gauge are the dependable comparison.

Reader questions

Questions & answers

No questions yet. Ask the first one.

All articles